Clicky

  Loading... Please wait...

Greenhouse Heaters

Please Note ! These heaters are not designed as Greenhouse Heaters

but I have installed the 30,000 btu model in one of my houses and it works great.

 

The Dyna-Glo heater is designed as a supplement heat source for homes, garage, basement, etc. It is NOT a wet environment heater. Because of this, the heater must be installed in a way that it can be protected from sprinklers or other water sources.

We are offering this type of heater because the Southern Burner company has closed their doors and no longer making their excellent heater.

The Dyna-Glo is a blue flame, vent free heater that can use either propane gas (LP) or natural gas (NG). Blue flame technology works by convection heat to warm the air the same way as a central heating system. The 30,000 btu model will heat an area up to 1000 sqft. Each heater model has a thermostat control knob so you can automatically maintain your desired heat level.  No electricity is required. The heat (flame) will cycle on and off depending on your setting of the knob control thermostat. The simple touch knob is as easy to use as your home thermostat. With 5 settings, setting '1' starts at approximately 55 degrees Fahrenheit, and setting '5' maxes out at approximately 118 degrees Fahrenheit. Each setting will dictate approximately a 12.5 degree Fahrenheit change in temperature.

Very easy to light. The heater has a built in ignition powered by 2 AA batteries (not included). Just press the ignition button while holding the control knob to light the pilot light.

The Dyna-Glo heater is designed to be installed on the wall, so there is no need to have extensive heat shielding behind the heater.

Optional feet are available to make it a truly free standing heat source. This stabilizes floor mounting of heater and will fit all Dyna-Glo models. Mounts to heater with two phillips head screws.

In addition, an optional fan can be installed to increase the warm air circulation and increase the amount of square footage the heat reaches in a quiet, yet powerful way. The fan has two operational modes. On and auto. You can turn the fan on and off or you can set it to auto mode and forget it. The fan will turn on automatically when the heater gets above 113 degrees Fahrenheit. This ensures it’s blowing ONLY warm/hot air. Comes with a 3' power cord.

Quick and easy installation. If the gas line is ready, this heater installs in about 5 minutes. No tools needed (except to tighten the gas line connection). If using the feet or fan, you will need a screw driver.

 image29.jpg

Sort by:
 

What's News

  • Your first blog post!

    Welcome to Orchid Supply Store!We launched our new and improved website in May …



newsletter

Follow us on

Copyright 2019 Orchid Supply Store. All Rights Reserved.
Sitemap |